Category: Jeep Grand Cherokee


Instructions

1.
Climb into your Jeep Grand Cherokee with your keyless remote(s) in hand and your manual ignition key. Do not close the driver’s door.
2.
Hit the “Lock” switch on your driver’s side door and insert the key into the ignition.
3.
Turn the key to the “Run” position and aim the keyless remote at the steering wheel. Press and hold the “Lock” button for five seconds.
4.
Wait for the locks to respond by cycling then program each successive remote (up to four total) by holding the lock until the locks respond. Each remote must be programmed within 20 seconds of the last.
5.
Turn the key in the ignition back to the “Off” position then quickly back to the “Run” position within 20 seconds of programming your last remote.
6.
Turn the car off and remove the key from the ignition to complete the programming sequence.

Credit to Matthew Fortuna

Instructions
Things You’ll Need:

* Keyless remote
* Key

1.
Open the Jeep Grand Cherokee’s driver door. This door must remain open during the entire procedure. Closing this door will cause the remote to not be programmed.
2.
Locate the receiver bulb on the ceiling of the passenger compartment. This is located near the windshield in the middle of the ceiling panel. This bulb receives the signal from the remote.
3.
Place the key in the ignition and turn the ignition switch to the “ON” position. Do not start the vehicle. Starting the vehicle will cause the remotes to not program.
4.
Lock the doors to the Cherokee using the power lock button. Make sure all of the doors lock.
5.
Point the remote at the bulb. Press and hold the “LOCK” button on the remote until the doors unlock.
6.
Turn the vehicle off and remove the key. Test the remote for proper operation.

Did it myself on my JGC 4.7 V8 and it worked 🙂

Credit to Michael Rippetoe